Inducon® in laser test

Laser Cutting of compression foam

Inducon® is a compression foam from the German company Mayser. It is a cellular polyurethane elastomer made of thermally compressed flexible foam. The unique composition and pore structure create unique material properties that are of great use for various industries.

eurolaser has now taken a closer look at Inducon®. The material was tested in the in-house application laboratory with regard to the properties during laser machining.

Benefits of cutting Inducon® with CO₂ lasers:

  • Lint-free and dust-free processing
  • Clean and sealed cut edges
  • Tool wear is very low - a knife causes increased use of material compared to laser cutting and wear would become increasingly uneconomical
  • No reworking of the edges with other tools necessary
  • Engravable - Markings can be applied directly in one single step
  • Cost reduction - further processing possible without additional testing
  • Fine, radius-free contours
Scope of application

Scope of application


Due to its special properties, Inducon® is mainly used in the automotive industry as well as in automation and logistics. It acts, for example, as a spacer, has an anti-slip effect, acts as a seal, filter or fluid reservoir, can be found in car interiors or serves as a carrier for adhesive tape. 

Properties of Inducon®

  • Resistant to chemical substances
  • Fire resistant version available
  • High elasticity
  • Good damping properties
  • Good solvent resistance
  • Optional: self-adhesive
Laser tested by eurolaser

eurolaser has tested the following Inducon® variants for their laser cutting ability:

Certificate as PDF

INDUCON® S90
Suitability for laser cutting: excellently suitable

Certificate as PDF

INDUCON® S230
Suitability for laser cutting: excellently suitable

Certificate as PDF

INDUCON® S400
Suitability for laser cutting: excellently suitable

Certificate as PDF

INDUCON® SPPI 80
Suitability for laser cutting: excellently suitable

Certificate as PDF

INDUCON® TH300
Suitability for laser cutting: excellently suitable

Certificate as PDF

TG-TS30
Suitability for laser cutting: excellently suitable

Do you have any questions? We are pleased to advise you.

or please call for your individual consulting!

+33 3 21 11 07 70

 
© 1994 -2022 eurolaser GmbH. Tous droits réservés.